Could biochar amendment be a tool to improve soil availability and plant uptake of phosphorus? A meta-analysis of published experiments

Environmental Science and Pollution Research - As one of the most important nutrients for plant growth, phosphorus was often poorly available in soil. While biochar addition induced improvement of...     

Enhancing the adsorption function of biochar by mechanochemical graphitization for organic pollutant removal

• Mechanochemical treatment reduced the calcination temperature for biochar synthesis. • Biochar is converted to graphite after mechanochemical treatment. • Biochar was reduced to nanoscale after mechanochemical treatment. Biochar (BC) has been extensively studied as adsorbent for the treatment of water pollution. Despite the distinct advantages, the high calcination temperature and low adsorption capacity of pristine BC limit its practical applications. Most of the former studies focused on the structure and/or surface modification to improve the adsorption capacity of BC. However, the harsh experiment conditions involved in the biochar modification limited the application in industrial level. Herein, we introduced mechanical treatment into BC preparation to reduce the calcination temperature and improve the adsorption capacity simultaneously. The results indicated that the calcination temperature was reduced and the adsorption capacity of the treated BC was improved after mechanochemical treatment. Characterization of the samples disclosed that BCs were graphitized with the particle size reduced to nanoscale after treatment. Adsorption tests indicated that the mechanochemically treated BCs showed much better removal performance of organic contaminants than that of pristine BCs. For instance, among four pristine BCs (BC600, BC700, BC800, and BC900), only BC900 has strong adsorption capacity for MB, while BC600 has low adsorption capacity (1.2 mg/g). By comparison, the adsorption capacity of MB increased greatly to 173.96 mg/g by BC600-500/1 (treated at 500 r/min for 1 hour). To optimize the mechanochemical treatment, the effects of rotation speed and agitation duration were also investigated.     

水中总氮测定方法存在问题的研究及改进

碱性过硫酸钾消解紫外分光光度法测定水中总氮采用的消解器皿是玻璃比色管,易造成空白偏高、结果偏低等问题。采用双圆柱状的消解杯对水样进行消解。结果表明,消解杯消解水中总氮,线性相关系数均大于0.999,检出限为0.05 mg/L,相对标准偏差小于5%,相对误差为0.88%~1.00%;改进后的消解器皿具有较好的精密度和准确度,能够更加准确测定水中总氮的含量。     

不同培养条件下锰过氧化物酶(MnP)的合成及其对甲基橙的降解

高效、大规模、低成本合成木质素降解酶是直接采用其降解难降解有机污染物所必须解决的问题.对锰过氧化物酶(MnP)降解甲基橙和在非灭菌的反应器中连续合成MnP的可行性进行考察.结果表明,在采用2 mmol H2O2和1.5 mmol MnSO4的降解体系中,获最大脱色效果,且100、200和300 U/L的MnP可在8h内将甲基橙分别脱色18％、23％和35％;在非灭菌的反应器水平上实现了固定化培养的P.chrysosporium连续23 d合成MnP,但MnP酶活仅为2～ 23 U/L,难以酶解甲基橙;然而,在摇瓶培养条件下固定化的P.chrysosporium合成的MnP却能达1 152 U/L.因此,直接采用MnP对污染物进行降解以及在非灭菌的反应器中持续合成MnP是可行的,但就在非灭菌条件下如何提高MnP的合成量还有待开展深入的研究.     

pH对铝盐絮凝剂形态分布与混凝除氟性能的影响

对比研究了AlC13和3种不同碱化度的聚合氯化铝(PACl)在不同pH与投量下除氟效果,并对不同形态铝盐除氟机理进行了初步探讨.结果表明,pH对絮凝剂水解后铝形态分布及其除氟效果有重要影响.pH 5 ～6时,Al3+和Al2、Al3等低聚态铝为AlCl3主要形态,且AlCl3更易水解生成可将溶解态氟转化为颗粒态氟的Al(OH)3,从而较PACl具有更佳除氟效果.pH ＞7时,PACl较AlCl3具有更佳除氟效果,且增大PACl碱化度可促进氟的去除,这主要是由于具有较高Al13含量的PACl更容易与电负性F-结合所致;且絮凝剂混凝除氟絮体ζ电位越高,越利于F-在絮体表面吸附.     

气质联用法测固定污染源中三氟甲烷、四氟甲烷、六氟乙烷和六氟化硫

建立了固定污染源排气中三氟甲烷、四氟甲烷、六氟乙烷和六氟化硫的采样和气质联用分析方法,检出限分别为0.06、0.15、0.21、0.71 mg/m3,精密度在3.2%以下,相关系数大于0.999 6,并对浙江省内2家典型企业排放的温室气体进行了监测,实际样品监测结果表明,该方法能够满足废气中4种温室气体的监测要求。     

蒽醌修饰石墨毡电极预处理头孢合成废水

以钛涂钌电极为阳极、自制蒽醌修饰石墨毡电极为阴极,对头孢合成废水(COD=25 000~30 000 mg/L、ρ(NH3-N)=850~1 300 mg/L、色度为2 300~2 680度)进行了电化学氧化预处理,优化了电解条件,并对电化学体系的动力学和稳定性进行了分析。实验结果表明:蒽醌的存在可改善电化学氧化降解效果;在电解时间50 min、电流密度0.14 A/cm2、Na2SO4浓度0.1 mol/L、极板间距2 cm、初始废水p H 7.0的条件下,废水的COD、色度、NH3-N的去除率分别可达45.3%,66.9%,33.6%;BOD5/COD由处理前的0.27增至0.40,可生化性得到改善;COD、色度、NH3-N的电化学氧化降解过程均近似符合一级动力学方程;且该电化学体系的应用稳定性良好。     

Preparation and Characterization of Xylan Derivatives and Their Blends

Although hemicellulose is found widely in nature, it is currently under-utilized as a raw material for commercial applications. It would be desirable to find new uses for hemicellulose in order to add value to this agro-based material. A common type of hemicellulose is xylan, which is found in a number of wood species and in cotton. In this work we prepared cationic and anionic xylan derivatives and characterized them by ¹³C NMR, FT-IR, size exclusion chromatography (SEC), thermal analysis, and rheology. In particular, the ¹³C NMR spectra of carboxymethyl xylan (CMX) and quaternary ammonium-adducted xylan (QAX) were fully assigned with the help of samples with different degrees of substitution. SEC indicated that the beechwood xylan showed a bimodal molecular weight distribution, but with derivatization the distribution tended to become unimodal. Thermal analysis and rheology studies did not uncover any surprises; the solution of xylan and its derivatives exhibited mostly Newtonian behavior. The blends of CMX and QAX produced a precipitate at almost all ratios, indicating the formation of a polyelectrolyte complex. When cationic and anionic xylan samples were added together to paper, the paper dry strength increased. Thus, the combination of cationic/anionic xylan may be of interest in selected applications.     

Adsorption of Ammonium by Graphene Oxide-Based Composites Prepared by UV Irradiation and Using as Slow-Release Fertilizer

A novel sodium alginate-grafted poly(acrylic acid)/graphene oxide (NaAlg-g-PAA/GO) composite hydrogel was prepared via ultraviolet irradiation, and characterized by infrared spectroscopy spectrometer. X-ray diffraction, X-ray photoelectron spectroscopy and scanning electron microscopy. It was employed to adsorb NH₄⁺ from aqueous solution and used as slow-release nitrogen fertilizers (SNFs). Result indicated that the adsorption process for NH₄⁺ reached equilibrium within 50 min, with the adsorption capacity of 6.6 mmol g^?1 even if 30 wt% GO was incorporated. The results of adsorption kinetic and isotherm were well described by the pseudo-second-order and Freundlich model. The thermodynamics analysis showed the adsorption process was spontaneous. The study indicated excellent water-holding ratio of soil with 2 wt% SNFs was 81.2%, and nitrogen release was up to 55.1% within 40 days in soil. Overall, NaAlg-g-PAA/GO could be considered as an efficient adsorbent for the recovery of nitrogen with the agronomic reuse as a fertilizer.     

皂素和柠檬酸复合淋洗土壤中的钍

采用振荡淋洗和土柱动态淋洗实验研究了皂素和柠檬酸复合对土壤中钍的淋洗性能。实验结果表明:将质量浓度为20 g/L的皂素与浓度为20 mmol/L的柠檬酸以体积比1∶10配制复合淋洗液对污染土壤中钍的去除效果最佳,淋洗3.0 h,钍去除率为84.98%;准一级动力学方程能更好地描述复合淋洗液对钍的淋洗动力学特征;动态淋洗实验中当复合淋洗液用量为1 600 mL时,钍的累积去除量为73.66 mg/kg;淋洗后土壤中钍的酸可提取态、氧化结合态和有机结合态含量分别减少了79.63%、38.13%和20.34%,残渣态含量变化不大;淋洗后土壤中钍的稳定性增加。